100k Thermistor

Rated 4.00 out of 5 based on 1 customer rating
(1 customer review)

2.00 Ex. VAT


3950 1% thermistor
1.8mm glass head
1M long cable with 2 wires
PTFE Tube 0.6*1mm to protect from the heat of the hotend
Shrink wrap between thermistor and the cables

Uses and included on our heated beds and usable in a hotend.

100k-thermistor datasheet

Additional information

Weight 20 g

1 review for 100k Thermistor

  1. Rated 4 out of 5

    Anne Archibald (verified owner)

    This thermistor is physically too big to fit properly into the E3D hot end, but I partly wedged it in and used heatsink goop to stick it in place. The printer prints fine, and it’s less delicate than the thermistor that comes with the hot end (which I broke, hence the hack). It seems this thermistor should use table 11 in the Marlin firmware.

    • Ardon

      That is correct. It is not suited for the E3Dv6 but you can use it in an emergency like you describe.

Add a review